JSM Micro IN32B Universal Interface is ideal for residence owners who want to replace their existing emergency call system, without replacing all the call devices. These will then be connected to our Universal Interface which, in turn, will communicate with VIGILANCE Central Controller (WSX1) to handle emergency calls.
The table bellow compares the limits and possibilities of a system using this interface versus a full VIGILANCE system.
Systeme with IN32B Interface
All swith type (on/off) call devices
JSM Micro Enhanced Call Devices
CALL DEVICE INTERFACE
IN32B Universal Interface
RTU-8 Enhanced Controle Module
PRIORITY CALL LEVELS
Enhanced Support (flashing, colors)
CALL DEVICE SUPERVISION
CALL DEVICE CONNECTION
Basic JSM Report
Enhanced JSM Report
Technically, the IN32B interface monitors circuits or mechanical contacts such as lamps, relay contacts, switches, thermostats, alarms, etc. The status of the overseen devices is conveyed to a central controller (WSX1) which will react in accordance to its onboard firmware. For example, information can be stored, displayed on monitors, relayed to pagers, etc. The IN32B can detect steady or flashing signals on the same pin. Supervised mode is possible with steady signals only.
Micro controller driven
Field programmable, no PC required.
Accept dry contacts, N.O. or N.C.
Accept voltages 5-30 volts AC/DC
Accept supervised contacts
Active supervision mode, 10 seconds
Optically isolated inputs
Light grey cold rolled steel enclosure
7.5 to 12 volts DC powered
Cage Clamp (no screw) connectors
Power: 12 VDC, 140 ma (90 typical)
Programming: RS232 or manual (EEPROM holds configuration)
Network: RS485 (1 km shielded 1 pair cable or cat 5 cable)